DHH type single-stage sliding line product 
H-type single-stage slide installation precautions Installation instructions:
Important installation instructions:
1) Assemble the suspender to adjust the suspension bolts to ensure the straightness and parallelism error between the horizontal and vertical directions of each conductor. The value must not exceed 5mm.
2) Connect the guide rail to the conductive plate and grind it with an emery cloth to remove the chlorinated layer and wipe it clean. Apply a conductive paste with a thickness of about 0.2 mm to reduce the contact resistance.
3) Installation of power supply In addition to the DHS-1600 and DHS-2000 type lines, open the cable holes on both sides of the connection cover. The size of the opening is generally 2mm smaller than the outer diameter of the cable.
DHS-1600 and DHS-2000 type slide wire, just according to the wiring diagram to determine the installation location to access.
4) The installation of the collector shall be based on the number of poles of the collector and the installation space to determine the length of the tractor (universal type);
For JDT type collectors, please refer to the current collector section in this chapter. JDS type collectors are usually mounted to the collector crossbar to maintain horizontality.
After the installation is completed, release the limit nut and remove the limit plate so that the collector can move freely up and down.
5) Check the parallelism between the slide line and the hoisting running track, and check that no fasteners are larger than 20mm.
After 1 month of continuous use, tighten all fasteners once.
H-type single-stage slide wire installation in several forms:
H-type single-stage slide installation precautions Installation instructions:
Important installation instructions:
1) Assemble the suspender to adjust the suspension bolts to ensure the straightness and parallelism error between the horizontal and vertical directions of each conductor. The value must not exceed 5mm.
2) Connect the guide rail to the conductive plate and grind it with an emery cloth to remove the chlorinated layer and wipe it clean. Apply a conductive paste with a thickness of about 0.2 mm to reduce the contact resistance.
3) Installation of power supply In addition to the DHS-1600 and DHS-2000 type lines, open the cable holes on both sides of the connection cover. The size of the opening is generally 2mm smaller than the outer diameter of the cable.
DHS-1600 and DHS-2000 type slide wire, just according to the wiring diagram to determine the installation location to access.
4) The installation of the collector shall be based on the number of poles of the collector and the installation space to determine the length of the tractor (universal type);
For JDT type collectors, please refer to the current collector section in this chapter. JDS type collectors are usually mounted to the collector crossbar to maintain horizontality.
After the installation is completed, release the limit nut and remove the limit plate so that the collector can move freely up and down.
5) Check the parallelism between the slide line and the hoisting running track, and check that no fasteners are larger than 20mm.
After 1 month of continuous use, tighten all fasteners once.
H-type single-stage slide wire installation in several forms:
Glass Latch,Glass Gate Latch,Glass Door Latches,Sliding Glass Door Latch
DONGYING SHENGYU METAL PRODUCT CO.,LTD , https://www.castingprocess.com