Beijing Youth Daily reporter learned from the Municipal Motor Vehicle Emission Management Center yesterday that in the future, the city will realize 24-hour uninterrupted monitoring of vehicle exhaust emissions. Even if there is no on-site inspection by law enforcement personnel, owners who fail to discharge exhaust gas will be punished. It is understood that before 2017, the city will invest 150 sets of fixed remote sensing monitoring equipment, mainly distributed in key sections of urban traffic trunk roads, loop trunk roads, and Jingjingkou, and implement 24-hour emission of vehicles on the road. monitor.
From the current situation, the remote sensing monitoring vehicle on the road to monitor the exhaust emissions of motor vehicles is the main law enforcement means of vehicle emission management in this city. There are a total of 86 remote sensing monitoring points in the city, which will be punished for on-site law enforcement and off-site enforcement of vehicles with excessive emissions. The biggest advantage of remote sensing monitoring vehicles is that they are flexible and easy for law enforcement personnel to conduct surprise inspections, but the disadvantage is that they require manual operation. Therefore, some vehicles that do not meet the emission standards often choose to go on the road at night in an attempt to escape punishment.
According to the Beijing 2013-2017 Clean Air Action Plan
In the deployment of the plan, hundreds of sets of fixed remote sensing monitoring equipment were installed in the main sections of the city, and 24-hour “seamless†supervision was implemented on the vehicles on the road, which greatly reduced the total amount of pollution. According to Li Tao, deputy section chief of the Supervision Department of the Municipal Motor Vehicle Emission Management Center, before 2017, the city will build 150 sets of fixed remote sensing monitoring equipment, and 20 sets of remote sensing monitoring vehicles will be monitored at the same time.
Li Tao said that the fixed remote sensing monitoring equipment works in the same way as the remote sensing monitoring vehicle. Its biggest advantage is that it can work 24 hours. The location suitable for the installation of fixed remote sensing monitoring equipment should meet the two conditions of “vehicle interval is 1 second, non-downhill sectionâ€. On this basis, the instrument should be installed in the area where the vehicle is concentrated.
According to the preliminary plan, the 150 sets of fixed remote sensing monitoring equipment will be distributed in key sections such as urban traffic trunk roads, loop trunk roads and Jinjingkou. Once the vehicle with excessive exhaust gas is found, the vehicle information will be transmitted to the terminal system of the Municipal Environmental Protection Bureau. The database of the Environmental Protection Agency is expected to be connected with the database of the transportation department to realize real-time sharing of data.
related news
Exhaust gas exceeding the standard car will be fined 3,000 yuan
This newspaper (reporter Wang Bin) Beiqing Daily reporter learned from the environmental protection department yesterday that the relevant departments recently carried out strict enforcement of the motor vehicles on the roads of the city and the vehicles entering the Beijing junction, and found that there are still exhaust vehicles on the road.
The reporter of Beiqing Daily learned from the Municipal Vehicle Emission Management Center that during the inspection period, all large vehicles or small cars that fail to meet the standards and violate the rules will be punished according to the maximum limit, that is, a fine of 3,000 yuan.
On November 8, the law enforcement officers of the Municipal Environmental Protection Bureau came to Yanqing County to carry out motor vehicle law enforcement inspections, using remote sensing monitoring vehicles to strictly check the emissions of road vehicles. From 0:00 to 19:00, a total telemetry vehicle
2,678 vehicles were found to have 30 exhaust vehicles. At the entrance to Kangzhuang in Yanqing County, environmental law enforcement officers conducted law enforcement inspections on vehicles entering Beijing. From 0:00 to 19:00 on the 8th, a total of 1,034 vehicles were imported into Beijing, and one vehicle was oversold.
The relevant person in charge of the Municipal Motor Vehicle Emission Management Center said that from 0:00 on November 3 to 4:00 on November 11, all large vehicles or small cars that fail to meet the standards are subject to the maximum penalty. The usual standard is that a large-scale vehicle exceeding the standard will be fined 500 to 3,000 yuan, and a super-standard car will be fined 300 to 3,000 yuan. However, during the APEC meeting guarantee period, a fine of 3,000 yuan will be imposed.
Poly Aluminium Chloride is referred to as PAC. It is also commonly called basic aluminum chloride or coagulant. It is a new type of high-efficiency inorganic polymer flocculant. Its aqueous solution is a hydrolysis product between aluminum trichloride and aluminum hydroxide, with a colloidal charge, so it has a strong adsorption on suspended matter in water. To achieve the purpose of condensing suspended matter in water. The Polyaluminium Chloride produced by Jinhe are white, yellow or light yellow powder.
Polyaluminum Chloride has the functions of removing suspended matter, COD and BOD, degreasing, decoloring, removing heavy metals and residual chlorine in water, etc. It is mainly used for purification treatment of tap water and industrial wastewater. Polyaluminum chloride is currently the most widely used inorganic coagulant in water purification processes. There is no need to adjust the pH value of the source water, it has a wide range of adaptation to the pH value of the source water, which is unmatched by traditional inorganic low molecular coagulants.
Polyaluminium Chloride is used in metallurgical, electric power, tanning, medicine, printing and dyeing, papermaking, chemical and other industries` sewage treatment.It`s also used in tap Water Treatment. Its coagulation effect forms flocs (also known as alum flowers) fast, the particles are large and heavy, and the sedimentation is fast. The applicable PH value ranges from 5 to 9, and has the characteristics of low dosage, low cost, high activity, convenient operation, wide adaptability, and low corrosion.
Poly Aluminium Chloride,White Poly Aluminium Chloride,Yellow Poly Aluminium Chloride,Brown Poly Aluminium Chloride
Yucheng Jinhe Industrial Co.,Ltd , https://www.hnchromiumoxidegreen.com