Loader scales have relatively high operating requirements for the driver

Loader scales have relatively high operating requirements for the driver

During the weighing process, the loader scale () has a relatively high operating requirement for the driver. No matter the road slope, the throttle force, the speed of the power lifting arm, the cylinder mass, etc. are the main factors affecting the weighing of the loader, Reduce the loader's weighing error and ask the driver to properly load the machine scale in the following operations.

First, all weighing must be in the retracted state after the loader shovels

Second, choose a relatively flat road for weighing, in order to reduce the slope of the weight error brought about by the weight.

Third, in the weighing (especially when lifting the lifting arm to the proximity sensor switch) must not relax the throttle, so that the loader at a steady state through the position switch sensor.

Fourth, pay attention to the weight of the bucket must be lifted from the bottom, do not lift from the middle.

5. During the weighing period, we must keep the weighing method of “moving the bucket and moving the bucket without moving the truck” and avoid shaking the vehicle body during the weighing process.

6. Pay a sufficient amount of butter into the filling hole of the loader at a regular time to avoid the error caused by the friction and reduce the service life of the sensor.

7. After the weighing instrument is turned on, it needs to have a preheating time of 10 seconds. After warming up, it must be weighed once to release the electrostatic value of the instrument. Otherwise, occasionally there will be an electrostatic error ranging from 2000kg, when similar electrostatic weight appears. Please reset the meter to normal weighing.