Bread van is also one of the most common models in our daily life. Compared with a sedan, it can carry more goods and people, but only if it does not violate the rules. Bread lorries are generally categorized by the use of functions and the number of seats, so where should the vehicle's adoption be?
1. When checking the coolant level for bread vans, be sure not to leave the lid of the radiator open while the engine is still in the heat engine. Otherwise, the high-temperature steam or coolant that was sputtered out will burn. Wait patiently for the engine to cool naturally. After checking, if the liquid level of the coolant is between the low level and the high level, if it is lower than the low level, it is necessary to immediately add the cooling liquid or distilled water. After filling the water, the height of the liquid surface is not Should be higher than high.
2. When checking the battery of the bread truck, it is necessary to pay attention to whether the battery is firm and reliable. The liquid level of the electrolyte should also be between the low level and the high level. If the liquid level is close to the low level, it needs to be timely. Add distilled water or electrolyte. It is necessary to ensure that the positive and negative battery cables of the vehicle are in good contact, and that the battery is kept clean and dry at all times.
3. If the brake fluid level of the bread truck is also between low and high, then the proof is sufficient. If the liquid level is already near the downline, consider whether the brake shoe is worn too much or if there is a leak in the system. Check and repair immediately. When filling the bread wagons with coolant, be sure not to mix and use the brake fluid. This will cause damage to the bowl.
4, the bread truck parked on the road parallel to a level, the Vernier out to check the oil level, if the oil is between the two performance of L and F, then the oil is in normal use Range, if the liquid level is lower than the L mark, then it is necessary to add the oil specified by the bread lorry to use the signal. Note that the liquid level cannot be higher than the F mark after filling the oil.
5, the van truck clutch master cylinder liquid level between the low and high also means that normal, if the liquid level has been at a low mark, there may be a sub-pump of the bowl or the main pump there is damage. When the van's engine is in operation, there is a situation where it is impossible to stop or stop the gear, and maintenance must be performed.
Hydraulic Pipe Bending Machine
CTK-NC series single-head high-speed hydraulic Pipe Bending Machine is a product developed by our factory on the basis of absorbing advanced technology at home and abroad. The product is hydraulic transmission, PLC control, and man-machine dialogue operation using touch screen. The whole machine has the advantages of convenient operation, stable performance and high production efficiency. It is an ideal equipment for the pipe fittings processing industry, especially the stainless steel pipe fittings processing industry.
Hydraulic Pipe Bending Machine,Hydraulic Pipe Bender,Hydraulic Tubing Bender,Air Hydraulic Pipe Bender
GUANGDONG CHITTAK INTELLIGENT EQUIPMENT CO.,LTD , https://www.ctklasercutter.com