(1) According to the “Specifications for Geological Exploration of Salt Lake Mineral Deposits†(Trial), the general industrial indicators of the Shiyan Salt Lake deposits provided in 1993 are shown in Table 1.
See Table 2 for the technical and feasible comprehensive evaluation indicators of the companion (co-) component of the salt lake minerals.
Examples of mineral industry indicators: Jilantai Lake Salt Mine, Inner Mongolia 1) Solid phase rock salt: cut-off grade NaCl > 35%, industrial grade NaCl > 65%; CaSO 4 is not controlled by indicators, but the content is 5% alone; The thickness is not less than 0.5 m (from the stripping of the halogen cover).
2) Intercrystalline brine and confined brine: The exploration engineering control boundary is the ore range, and the concentration is above 20°Be/15°C (relative density is 1.161), which is converted into off-balance sheet reserves.
3) Glauber's salt (below the solid phase salt layer): the content of Na 2 SO 4 content greater than 30% is the off-balance sheet reserve.
(2) According to the National Mineral Reserves Administration “Guidelines for Geological Exploration of Salt Deposits†(Draft for Comment), the industrial indicators of rock salt and underground brine deposits (Table 3) provided in 1988 are as follows:
According to the "Mineral Industry Requirements Reference Manual" edited by the National Mineral Reserves Committee, the general industrial indicators for rock salt deposits in 1987 are: boundary grade NaCl ≥ 10% ~ 15%; industrial grade NaCl ≥ 20% ~ 30%; ore grade NaCl: Grade I products are ≥86%, Grade II products are 61% to 85%, Grade III products are 30% to 60%, and pit mining methods are available for thicknesses of 0.3 m.
Example of mineral industry index: Hubei Yunying Salt Mine The mine is produced by water-soluble method. The industrial indicators are:
(1) Rock salt quality requirements The thickness of the salt layer unit layer is ≥0.1 m, the boundary grade is NaCl≥35%; the salt group (mineral body) cumulative pure salt thickness is ≥1.5 m; the salt group ore concentration is ≥40%;
Harmful impurity content (water soluble): Pb < 0.0001%, Ba < 0.002%, Mg < 0.5%, and As, F and Zn are <0.0005%.
(2) Mining technical conditions Mining height: no more than 25 m; maximum stone thickness: hard rock ≤ 1.5 m; mudstone or calcium thenardite ≤ 2 m; minimum mining depth: 200 ~ 270 m.
A Tower Crane anchorage frame is a structural component used to secure a tower crane to the ground or a building during its operation. It is typically made of steel and designed to withstand the high loads and forces exerted by the crane.
The anchorage frame consists of a base plate or foundation, which is securely attached to the ground or building structure. It also includes vertical support beams or columns that provide stability and strength to the frame. These columns are connected to the base plate and extend upwards to support the tower crane.
The anchorage frame is designed to distribute the loads from the crane's operation evenly and safely to the ground or building structure. It must be able to withstand the weight of the crane, the loads lifted by the crane, wind forces, and other external factors.
The design and construction of a tower crane anchorage frame must comply with local building codes and regulations. It is typically engineered by a structural engineer to ensure its strength and stability.
Proper installation and regular inspections of the anchorage frame are essential for the safe operation of a tower crane. Any signs of damage or deterioration should be addressed immediately to prevent accidents or structural failure.
Jacking Part Anchorage Frame,Tower Crane Anchorage Frame,Mast Section Anchorage Frame,Anchorage Frame For Tower Crane,Tower Crane Anchor
SHEN YANG BAOQUAN BUSINESS CO., LTD , https://www.sczenghui.com