High-altitude truck safety operation regulations

1. Personnel who have not qualified for training and have obtained operation and driving qualification certificates are strictly prohibited from operating aerial vehicles.
Second, before driving preparation 1, should carefully read the instructions before the operation, to understand the driving, use requirements, to master the vehicle performance parameters. 2. Check the chassis oil level, water level, etc. before using the chassis as required. 3, check the fuel tank level. (Need to consider the fuel consumption of high altitude and lifting operations) 4. Check the hydraulic oil level to ensure that the amount of oil in the hydraulic tank reaches the specified value. 5. Check if the upper and lower arms are in position and do not float. 6. Check if there are any missing tools or items in the work platform. If so, remove them promptly. When the vehicle is traveling, there is no fixed item inside the work platform. 7. Check if the legs are fully retracted. 8. Check whether the power lever has decoupled the power take-off gear from the car gearbox
Third, the choice of workplace 1. Workplace ground allowable maximum tilt angle of 5 °. If you need to work on a slope, you should park the nose in the direction of the top of the hill. 2. When working on the highway, the distance between the body and the edge of the road should be no less than 760mm (outrigger extension length), and turn on the hazard warning light in time. 3. The work vehicle must not work in a fire or explosion hazardous area or in a corrosive environment. 4. The operating temperature range of the work vehicle is -25°C~40°C, and it is not allowed to work outside this range. 5, Relative humidity is not more than 90% (25°C). 6. Work is forbidden when light is dim or when visibility is low. 7, the altitude does not exceed 1000m. 8. When the wind exceeds level 6, the operating vehicle must not work. 9. When there is a wire passing through the work area, it should always maintain a sufficient safety distance. 10. The work vehicle studio should maintain a sufficient safety distance from the cliffs and ditches.
Fourth, other safety matters 1. It is forbidden to overload the work. It is forbidden for the operator to carry out aerial operations without a safety belt. 2. It is forbidden to use ladders, ladders, and other elevations during operation, and it is forbidden to focus the body out of the floor of the working platform. 3. It is forbidden to throw items from working platforms or working platforms. 4. It is forbidden to lift and ascend the work of colleagues. 5. It is strictly forbidden to use a hook to lift an object that is buried in the ground and is not known. It is forbidden to drag the weight in a horizontal direction to avoid accidents caused by overloading. 6. When working, it is forbidden to stand under the boom. 7. When working at heights, there should be an operator next to the vehicle, ready to carry out emergency operations. 8. Do not change the set value of the hydraulic valve. 9. It is forbidden to drive the vehicle when the power take off gear is not disengaged.

Four Wheel Electric Vehicle

Four Wheel Electric Vehicle,Mini Four Wheel Car,4 Wheel Electric Car,4 Wheel Electric Vehicle

Xuzhou Hengshang Mechanical and Electrical Co., Ltd. , https://www.hengsenergy.com