The following phenomena occur in the electronic scale. It is doubtful that the load cell is faulty:
(1) The electronic scale does not show zero and the display keeps blinking.
(2) After the electronic scale displays zero, weights are added and weights are not displayed.
(3) The weighing of electronic scales is inaccurate. The displayed weighing figures are inconsistent with the number of adding and releasing weights.
(4) The repeatability of electronic scales is not good, plus the same weight, sometimes weighing accuracy, and sometimes weighing is not accurate.
(5) When the electronic weigher is unloaded or loaded, the displayed figures are unstable, drifting or jumping.
All these phenomena can be the failure of the load cell. If you can accurately determine that the fault is in the sensor, this will greatly increase work efficiency and speed up the repair of electronic scales. The sensor that needs to be judged is removed from the system and the input impedance and output impedance are measured. The normal value of the input impedance is 380Ω, and the normal value of the output impedance is 350Ω. If the measurement data is not within this range, the sensor is damaged. If the input impedance and output impedance are disconnected, check whether the sensor signal cable is disconnected. When the signal cable is intact, the sensor strain gauge is burned, usually because of the large current entering the sensor. When the measured input impedance and output impedance are not stable, the insulating layer of the signal line may be broken, the insulation performance may be degraded, or the sensor may get wet, so that the bridge is not insulated from the elastic body. The zero output signal value of the sensor is generally between (-3mv and 2mv). If it is far beyond the scope of this standard, it may be due to the plastic deformation of the elastomer caused by the overload of the sensor, making the sensor unusable. If there is no zero signal or zero output signal is very small, it may be that the strain gauges in the load cell have been detached from the elastic body or there is support to support the scale body.
Two-piece slackline is fully adjustable and easily installed between trees or other sturdy anchor points.
Improve balance skills, core strength, and coordination while having fun.
Kit includes slackline, ratchet tensioner, and tree protection
The easy-to-use ratchet comes with 8 feet of webbing and a reinforced loop to firmly anchor and tension the slackline. The handle grip is a soft plastic for comfortable and efficient tensioning and the ratchet release is also rubberized for easy and safe release of the tension on the line.
The included HELP LINE with arm position trainer mounts above the slackline. Another piece of webbing acts as an arm position guide to assist with balance and form.
Custom-designed beginner webbing with rubber grip is optimized for quick and easy learning.
Slackline Kit,Ninja Slackline Kit,Slackline Kits Baseline,Slack Rope,Slack Lines
WINNERLIFTING SAFETY EQUIPMENT CO., LTD. , https://www.ratchetstrapfactory.com