Car park management system can do maintenance to avoid hidden troubles

The parking lot management system equipment belongs to electronic machinery products and needs to be maintained regularly. It is recommended that the equipment be checked and maintained every six months. During maintenance, system maintenance should be performed when the power is turned off. If the following problems are found in the maintenance process, they should be promptly resolved.
 

The parking lot management system equipment maintenance project includes:

1, the device's power supply voltage: Check the device's power supply voltage has reached the standard.

2. Wiring of the equipment: Check whether the communication connector between the components is firmly connected and loosened and tightened immediately.

3, control machine chassis: Check the chassis is loose, once found loose, must be tightened.

The daily maintenance of the parking management system has the following aspects:

1, a dust removal process is performed on the equipment every 60 days;

2. Perform a comprehensive inspection of the mounting screws of each device every 60 days. Once loosening is found, they must be tightened;

3, all temporary cards must be straight, each time before loading the card must be checked again, once found bent card can not be installed in the card out of the institution;

4, every 60 days to check the communication connector between the components is firmly connected, found loose, and immediately tighten;

5. Regularly check if the “Card Take” and “Call” keys are flexible. If not, adjust them.

6. Check whether the cooling fans in various chassis are working well. If they are not found, they should be replaced in time.

Daily inspection of parking management system:

In order to ensure the safe and reliable operation of the automatic doors, OPTIMA Automatic Doors recommends that the user or the automatic door manager perform the necessary operation checks on the automatic doors during daily use.

Test checks need to be performed without interference from other people:

1. The inspection personnel shall move from the outside or inside the door to the automatic door at normal speed. The automatic door shall open automatically. The movement of the automatic door shall be smooth and there shall be no collision. After the automatic door is opened, the personnel will be about 150mm-200mm per second. When the speed is slow through the automatic door, the automatic door should remain open;

2. When the inspector leaves the detection area of ​​the automatic door sensor, after the time delay of 1-10 seconds (the length of time can be set by the automatic door switch parameter), the automatic door will be automatically closed, the action of the automatic door should be smooth and no collision occurs. Case;

3. Observers normally pass the walking route of the automatic door, and need to adjust the daily walking route to the person walking towards the automatic door, instead of going to the automatic door at a certain angle;

4. When it comes to the automatic door, the sensing width of the automatic door sensor should be greater than the width of the fully opened door;

5. If the automatic door is equipped with an auxiliary safety light sensor (infrared radiation protection device), when the automatic door leaf is opened, the person stands still, and the auxiliary safety light sensor is blocked by hand, and the door should be kept open. The door should be closed again within a few seconds of the hand leaving.